210
off. Adjust it (page 76, 90, 112, 117).
• When one handset is selected to ring for cellular
calls, other units do not announce caller
information. To change the selection, see page 59.
• The Talking Caller ID feature is turned off. Turn it
on (page 117).
• The ring as cell mode is set to “On (without
Talking CID)”. To change the mode, see page
59.
• The number of rings for the answering system is
set to “2 rings” or “Toll saver”. Select a
different setting (page 171).
• Your unit does not announce caller information if
– the base unit or 2 or more handsets are on a
call.
– a headset is in use.
Problem: The caller list/incoming phone numbers
are not edited automatically.
Cause/solution:
• The Caller ID number auto edit feature is turned
To Next Page
Loading...
