Panasonic KX-TG9333

Making calls
Using the handset
1 Lift the handset and dial the phone
number.
•
To correct a digit, press [Clear].
2 Press [~] or [Call].
3 When you finish talking, press
[OFF] or place the handset on the
base unit or charger.
Using the speakerphone
1 Dial the phone number, and press
[~].
• Speak alternately with the other
party.
2 When you finish talking, press
[OFF].
Note:
• For best performance, use the
speakerphone in a quiet environment.
•
To switch back to the receiver, press
[~].
Adjusting the receiver or speaker
volume
Press [,,] or [T] repeatedly while
talking.
Making a call using the redial list
The last 5 phone numbers dialed are
stored in the redial list (each 48 digits
max.).
1 [REDIAL]
2 [T ]/[,,]: Select the desired phone
number.
3 [~]
Erasing a number in the redial list
1 [REDIAL]
Making/Answering Calls
2 [T ]/[,,]: Select the desired phone
number.
3 [Erase] ~ [Yes] ~ [OFF]
Pause (for PBX/long distance service
users)
A pause is sometimes required when
making calls using a PBX
or long
distance service. When storing a calling
card access number and/or PIN in the
phonebook, a pause
is also needed
(page
22).
Example: If you need to dial the line
access number"9" when making outside
calls with a PBX:
1 [9] ~ [PAUSE]
2 Dial the phone number. ~ [~]
Note:
• A 3.5 second pause is inserted each
time
[PAUSE] is pressed. Repeat as
needed to create longer pauses.
Using the base unit
Available for:
KX- TG9341/KX- TG9342/
KX- TG9343/KX- TG9344
1 [SP-PHONE]
2 Dial the phone number.
3 When the other party answers,
speak into the MIC.
• Speak alternately with the other
party.
4 When you finish talking, press [SP-
PHONE].
Note:
• Use the speakerphone in a quiet
environment.
• While on a call, you can switch from
the base unit to the handset:
For assistance, please visit http://www.panasonic.com/help 17