Panasonic KX-TG9472B

If you use the unit as a single-line telephone
o
nly
Be sure to connect the telephone line cord to LINE
1/2. Change the line selection mode from “Auto”
to “Line1” (page 14).
“Transparent” plug
To single-line
telephone
j
ack (RJ11C)
2-wire cord
“Click”
Note:
R “C
heck tel line 2” is displayed on the unit.
To erase it, see page 45.
If you subscribe to a DSL/ADSL
s
ervice
Please attach a DSL/ADSL filter (contact your DSL/
ADSL provider) to the telephone line between the
base unit and the telephone line jack in the event
of the following:
– noise is heard during conversations.
– Caller ID features do not function properly.
To connect to a 2-line telephone jack
F
or this connection, please purchase a Panasonic
2-line splitter (page 4).
Example: DSL/ADSL line is line 2
To 2-line telephone
2-line
splitter
“Transparent” plug
DSL/ADSL
filter*
2-wire cord
4-wire cord
“GREEN” plug
“Click”
“Click”
“Click”
jack (RJ14C)
*DSL/ADSL filter (not supplied) is required if you
h
ave DSL/ADSL service.
To connect to 2 single-line telephone jacks
E
xample: DSL/ADSL line is line 2
“GREEN” plug
“Transparent” plug
2-wire cord
4-wire cord
To single-line telephone
jacks (RJ11C)
Line 1
Line 2
DSL/ADSL filter*
“Click”
“Click”
*DSL/ADSL filter (not supplied) is required if you
h
ave DSL/ADSL service.
Battery installation
R U
SE ONLY Ni-MH batteries AAA (R03) size.
R Do NOT use Alkaline/Manganese/Ni-Cd
batteries.
R Confirm correct polarities (
, ).
Rechargeable Ni-MH ONLY
For assistance, please visit http://www.panasonic.com/help
9
Getting Started