Panasonic KX-TG9581 - Getting Started; Initial Setup and Connections

Setting up
Connecting the AC adaptor/corded
h
andset
n Base unit
Connect the AC adaptor to the unit by
p
ressing the plug firmly.
Connect the AC adaptor to the power outlet.
Fasten the AC adaptor cord by hooking it.
*
1 After connecting the telephone line cord(s)
as shown on page 10, fasten the telephone
line cord(s) by hooking them.
Connect the corded handset cord to the
c
orded handset and the base unit until you
hear a click.
Note:
R Use only the supplied Panasonic AC adaptor
PNLV226.
2
3
3
*1
1
1
4
4
R F
ollow the directions on the display to set up
the unit.
n C
harger
Connect the AC adaptor to the power outlet.
1
Connecting the telephone line cord
R
efer to one of the following methods depending
on your situation:
– To connect to a 2-line telephone jack: page 10
– To connect to 2 single-line telephone jacks:
page 11
– If you use the unit as a single-line telephone
only: page 11
Connect the telephone line cord until it clicks into
the base unit and telephone line jack.
To connect to a 2-line telephone jack
Connect the “G
REEN” plug telephone line
cord (4-wire cord) (
1
) to the unit, then to the
2
-line telephone jack (RJ14C) (
2
) until you
h
ear a click.
2
“GREEN” plug
1
1
10
For assistance, please visit http://shop.panasonic.com/support
Getting Started
TG95x_OI(en-en)_0722_ver110.pdf 10 2015/07/22 12:33:21