Panasonic KX-TG9581 - Page 11

To connect to 2 single-line telephone jacks
For Line 1: Connect the “Transparent” plug
t
elephone line cord (2-wire cord) (
1
) to the
u
nit, then to the Line 1 single-line telephone
jack (RJ11C) (
2
) until you hear a click.
For Line 2: Connect the “G
REEN” plug
telephone line cord (4-wire cord) (
3
) to the
unit, then to the Line 2 single-line telephone
jack (RJ11C) (
4
) until you hear a click.
3
12
1
“Transparent” plug
“GREEN”
plug
2
4
If you use the unit as a single-line telephone
o
nly
Be sure to connect the telephone line cord to LINE
1/2. Change the line selection mode from “Auto”
to “Line1” (page 18).
Connect the “Transparent” plug telephone line
c
ord (2-wire cord) (
1
) to the unit, then to the
s
ingle-line telephone jack (RJ11C) (
2
) until
y
ou hear a click.
“Transparent” plug
2
1
1
Note:
R “C
heck tel line2” is displayed on the unit.
To erase it, see page 71.
If you subscribe to a DSL/ADSL
s
ervice
Please attach a DSL/ADSL filter (contact your DSL/
ADSL provider) to the telephone line between the
base unit and the telephone line jack in the event
of the following:
– noise is heard during conversations.
– Caller ID features do not function properly.
To connect to a 2-line telephone jack
F
or this connection, please purchase a Panasonic
2-line splitter (page 4).
Example: DSL/ADSL line is line 2
Connect the “Transparent” plug telephone line
c
ord (2-wire cord) (
1
) to the 2-line splitter
(
3
) until you hear a click.
Connect the “G
REEN” plug telephone line
cord (4-wire cord) (
2
) to a DSL/ADSL filter
(not supplied) (
4
), then to the 2-line splitter
(
3
) until you hear a click.
Connect the 2-line splitter (
3
) to the 2-line
t
elephone jack (RJ14C) (
5
) until you hear a
c
lick.
12
5
4
21
3
“GREEN”
plug
“Transparent”
plug
3
*DSL/ADSL filter (not supplied) is required if you
h
ave DSL/ADSL service.
For assistance, please visit http://shop.panasonic.com/support
11
Getting Started
TG95x_OI(en-en)_0722_ver110.pdf 11 2015/07/22 12:33:21