Panasonic KX-TG9581 - Battery Installation and Charging

To connect to 2 single-line telephone jacks
E
xample: DSL/ADSL line is line 2
Connect the “Transparent” plug telephone line
c
ord (2-wire cord) (
1
) to the unit, then to the
s
ingle-line telephone jack (RJ11C) (
2
) until
y
ou hear a click.
Connect the “G
REEN” plug telephone line
cord (4-wire cord) (
3
) to a DSL/ADSL filter
(not supplied) (
4
), then to the single-line
telephone jack (RJ11C) (
5
) until you hear a
c
lick.
2
5
4
3
12
1
“Transparent” plug
“GREEN”
plug
*DSL/ADSL filter (not supplied) is required if you
h
ave DSL/ADSL service.
Handset battery installation
R U
SE ONLY rechargeable Ni-MH batteries AAA
(R03) size (
1
).
R Do NOT use Alkaline/Manganese/Ni-Cd
batteries.
R Confirm correct polarities ( , ).
1
R F
ollow the directions on the display to set up
the unit.
Handset battery charging
C
harge for about 7 hours.
R Confirm “Charging” is displayed (
1
).
R W
hen the batteries are fully charged, “Fully
charged” is displayed.
1
Handset battery level
Icon Battery level
High
Medium
Low
Needs charging.
Empty
Panasonic Ni-MH battery performance
(
supplied batteries)
Operation Operating time
In continuous use
15 hours max.
*
1
Not in use (standby)
7 days max.
*
1
*1 If eco mode is on.
N
ote:
R Actual battery performance depends on usage
and ambient environment.
12
For assistance, please visit http://shop.panasonic.com/support
Getting Started
TG95x_OI(en-en)_0722_ver110.pdf 12 2015/07/22 12:33:21