Charge for about 7 hours.
R When the batteries are fully charged, “Fully charged” is displayed.
Note:
R The handset display may show “Please wait for 1 minute.” when the
handset is placed on the charger if it is not registered to the base unit.
R If the batteries are fully charged, but the operating time seems to be shorter,
clean the battery ends (
, ) and the charge contacts with a dry cloth and
charge again.
Display language
1 M
N(right soft key) #110
2 MbN: Select your desired language. a MOKN a MeN
Registering the handset to the base unit
Ensure that the handset is switched on. If it is not on, press and hold MeN for
few seconds to turn the handset on.
1 Handset:
Lift the handset and press MeN.
2 Base unit:
Press and hold M
N for about 5 seconds.
R Depending on the base unit, a registration tone sounds.
R If all registered handsets start ringing, press M
N again to stop, then repeat
this step.
3 Handset:
Place the handset on the base unit or charger.
4
Installation
To Next Page
Loading...
