8.1. Engineering Mode
8.1.1. Base Unit
Important:
Make sure the address on LCD is correct when entering new data. Otherwise, you may ruin the unit.
/ECO
Dial keypad
9).
Press
After that, turn the base unit power off and then power on.
2). Select "Initial Setup" using or
then press
{
OK
}
.
H/S key operation
{^} {V}
4). Enter "7", "2", "6", "2", "7", "6", "6", "4".
Note: 7262 7664 = PANA SONI
(see letters printed on dial keys)
6). Enter "
", " ", " ", " " (Address). (*1)
7). Enter "
", " " (New Data). (*1)
5). Select "Write EEP" using or
then press or
{>}
.
{^} {V}
3). Select "Line Setup" using or
then press
{
OK
}
or
{>}
.
{^} {V}
_ _ _ _ _ _
H/S LCD
Set Addr.:
Default Data
Set Addr.:
New Data
Set Addr.:
8). Press , a long confirmation beep
will be heard.
{
OK
}
Service Mode
Read EEP
Write EEP
{
OK
}
{Talk}{}
{
}
{}
Soft keys
(Volume) key/
(Phonebook)/
q
(Caller list) key/
R
(Redial) key/
Navigator key/
This pictured model is KX-TGC220
1). Press
{}
(Off/Power)
R
R
: Recall/Flash
ECO: Eco mode shortcut key
{
}
(Off/Power)
to return to stand by mode.
C
C
OK
OK
OK
To Next Page
Loading...
