Panasonic KX-TGD324AL - Page 31

1 MMENUN#
268
2 MbN: “On” a MOKN
3 MbN: Select the desired handset number
to monitor with. a MOKN
R “Baby Monitor” will be displayed.
R The registered handset name/number
is displayed.
Note:
R When this feature is on, another handset
can hear the monitored handset by making
an intercom call.
To monitor from an outside line
If
you enable this feature, the unit will call a
pre-programmed phone number when the
handset detects sound. After you answer the
call, you can listen in on the room where the
handset is located.
n From the phonebook:
1 MMENUN#268
2 MbN: “On” a MOKN
3 MbN: Select “External” to monitor
from an outside line. a MEDITN a
MADDN
4 MbN: “Phonebook” a MOKN
5 MbN: Select the phonebook entry. a
MOKN
R “Baby Monitor” will be displayed.
Note:
R If you edit a phonebook entry which is
assigned for monitoring, the edited entry
does not transfer to the monitor.
n By entering phone numbers:
1 MMENUN#268
2 MbN: “On” a MOKN
3 MbN: Select “External” to monitor
from an outside line. a MEDITN a
MADDN
4 MbN: “Manual” a MOKN
5 Enter the desired name. a MOKN
6 Enter the desired number. a MOKN 2
times
R “Baby Monitor” will be displayed.
Note:
R The
registered name/number is displayed.
Turning off the baby monitor
The
monitored handset cannot be used while
baby monitor is set to “On”.
1 Press MMENUN on the handset being
monitored.
2 MbN: “On/Off” a MOKN
3 MbN: “Off” a MOKN a MOFFN
Editing an outside monitoring number
1 Press MMENUN on the handset being
monitored.
2 MbN: “On/Off” a MOKN
3 MbN: “On” a MOKN
4 MbN: Select the outside line. a MEDITN
5 MMENUN a MbN: “Edit” a MOKN
6 Edit the name if necessary. a MOKN
7 Edit the phone number if necessary. a
MOKN 2 times
Erasing an outside monitoring
num
ber
1 Press MMENUN on the handset being
monitored.
2 MbN: “On/Off” a MOKN
3 MbN: “On” a MOKN
4 MbN: Select the outside line. a MEDITN
5 MMENUN a MbN: “Erase” a MOKN
6 MbN: “Yes” a MOKN a MOFFN
Baby monitor sensitivity
Y
o
u
can adjust the sensitivity of the baby
monitor. Increase or decrease the sensitivity to
adjust the sound level needed to trigger the
baby monitor feature.
R This feature cannot be set during a
monitoring call.
1 Press MMENUN on the handset being
monitored.
31
Programming
TGD32xAL(en)_1103_ver021.pdf 31 3/11/2015 1:59:53 PM