5 MbN: Select a memory location. a MOKN
6 E
nter the phone number or area code to
be restricted (8 digits max.). a MOKN a
MOFFN
Enhancing security for phone
cal
ls
You can increase the security of phone
conversations by setting this feature to
“Enhanced”. When “Enhanced” is selected,
is displayed. The default setting is
“Nor
mal”.
1 MMENUN#729
2 MbN: Selected the desired setting. a MOKN
3 MOFFN
Note:
R If you set repeater mode to “On”
(page 34):
– Security is set to “Normal” and
is
dis
played.
– “Security” is not displayed in the
display menu (page 25).
R When enhanced security is enabled, sound
may cut in and out during conversations.
Changing the base unit PIN
Imp
ortant:
R If you change the PIN (Personal
Identification Number), please make note of
your new PIN. The unit will not reveal the
PIN to you. If you forget your PIN, contact
an authorised service centre.
1 MMENUN#132
2 Enter the current 4-digit base unit PIN
(default: “0000”).
3 Enter the new 4-digit base unit PIN. a
MOKN
4 MbN: “Yes” a MOKN a MOFFN
Registering a unit
Operating additional units
Additional handsets
Up
to 6 handsets can be registered to the
base unit.
Important:
R The additional handset model
recommended for use with this unit is noted
on page 4. If another handset model is
used, certain operations may not be
available.
Additional base units
Han
dsets can be registered to up to 4 base
units, allowing you to add additional base units
and extend the area in which your handset(s)
can be used. If a handset moves out of range
of its base unit when “Auto” is selected on
base unit (page 34), it looks for another
base unit to make or receive calls. A base unit
and the handsets it communicates with is
called a “radio cell”.
Note:
R Calls are disconnected when the handset
moves from one radio cell to another.
Registering a handset to a base
uni
t
The supplied handset and base unit are
pre-registered. If for some reason the handset
is not registered to the base unit (for example,
is displayed even when the handset is
nea
r the base unit), re-register the handset.
1 Handset:
MMENUN#130
2 MbN: Select a base unit number. a MOKN
R This number is used by the handset as
a reference only.
3 Base unit:
Press and hold M
N for about 5 seconds.
R If
all registered handsets start ringing,
press M
N again to stop, then repeat
th
is step.
33
Programming
TGD32xAL(en)_1103_ver021.pdf 33 3/11/2015 1:59:53 PM
To Next Page
Loading...
