Note:
R I
f there is a handset that is not compatible
with Eco Plus registered to the base unit,
“Eco Plus” is not available. If that
handset is registered while “Eco Plus”
was already selected, the setting changes
to “Eco Off”.
R When there is another cordless phone in
use nearby, the base unit transmission
power may not be reduced.
R When eco mode is set to “Eco Plus”,
there is a delay between when calls are
received and when the handset starts
ringing.
R If the handset is registered to multiple base
units, the handset may not be able to make
or receive calls or communicate with the
base unit when the following conditions are
met.
– Eco mode is set to “Eco Plus”
(page 15).
– Base unit selection is set to “Auto”
(page 28).
In this case, place the handset near the
base unit, then press MECON and select
“Eco” or “Eco Off”. Repeat for each
base unit.
R When eco mode is active, the range of the
base unit is reduced in standby mode.
R If you set repeater mode to “On”
(page 35):
– Eco mode is disabled.
– “Eco Mode” is not displayed in the
display menu (page 27).
R When eco mode is set to “Eco Plus”,
battery usage time is shortened (page 12).
16
Helpline Tel. No.: U.K. 0344 844 3899 Ireland 01289 8333
Getting Started
To Next Page
Loading...
