To switch back to the receiver, press MZN/
M
N.
R I
n step 1, you can store the dialed phone
number to the phonebook by pressing and
holding MFN W for a few seconds.
Making a call using the redial list
T
he last 5 phone numbers dialed are stored in
the redial list (48 digits max. each).
1 MEN REDIAL
2 MbN: Select the desired entry.
3 M
N
Pause (for PBX/long distance service
u
sers)
A pause is sometimes required when making
calls using a PBX or long distance service.
When storing a calling card access number
and/or PIN in the phonebook, a pause is also
needed (page 40).
Example: If you need to dial the line access
number “9” when making outside calls with a
PBX:
1 9 a MDN (Pause)
2 Dial the phone number. a M
N
N
ote:
R A 3.5 second pause is inserted each time
MDN (Pause) is pressed.
Answering calls
1 L
ift the handset and then press M
N
or
MZN when the unit rings.
R To answer a cellular call, you can also
press MCELLN.
2 When you finish talking, press MOFFN or
place the handset on the base unit or
charger.
Any key answer: You can answer the call by
pressing any dial key.
Auto talk: You can answer calls simply by
lifting the handset (page 48).
Temporary handset ringer off: You can turn
the ringer off temporarily by pressing M
N
(left
soft key).
Adjusting the handset ringer volume
P
ress MDN or MCN repeatedly to select the
desired volume while ringing.
R To turn the ringer off, press MCN repeatedly.
Note:
R You can adjust the ringer volume for
cellular call and landline call by
programming (page 44, 46).
R The ringer volume you set is kept for each
line (landline and cellular lines).
One-touch ringer off for the handset
P
ress and hold 0 (
) until the unit beeps to
t
urn the ringer off. While the ringer is turned
off, the handset will not ring for calls.
R You can turn the ringer on again by
pressing and holding 0 (
) until the unit
b
eeps.
Useful features during a
call
Hold
1 P
ress MMENUN during an outside call.
2 MbN: “Hold” a MSELECTN
3 To release hold on the cellular line:
Press MCELLN.
*1
R Another handset user can take the call
by pressing MCELLN.
*1
*1 If you press MCELLN and the
selection list is displayed, select
the desired cellular line and press
MSELECTN.
R The base unit user can take the call by
pressing MCELL 1N or MCELL 2N.
To release hold on the landline:
Press M
N.
R A
nother handset user can take the call
by pressing M
N.
R T
he base unit user can take the call by
pressing MZN.
Note:
R After holding for 10 minutes, the call is
disconnected.
24
For assistance, please visit http://shop.panasonic.com/support
Making/Answering Calls Using the Handset
TGF57xUSA(en)_1201_ver031.pdf 24 1/12/2016 6:41:05 PM
To Next Page
Loading...
