Making cellular calls
Im
portant:
R The unit cannot be used to talk on 2 cellular
lines at the same time.
R Only 1 Bluetooth device can be used with
the unit at a time
*1
.
R Before making calls, confirm that the
corresponding
on the handset is
di
splayed (page 16).
*1 You cannot use a Bluetooth headset to
talk on a cellular line.
1 Lift the handset and then dial the phone
number.
R To correct a digit, press MCLEARN.
2 MCELLN
R The unit starts dialing immediately in
the following situations.
– Only 1 cellular phone is paired.
– A specific line is set to make cellular
calls (page 23).
Go to step 4.
3 MbN: Select the desired cellular phone. a
MSELECTN
4 When you finish talking, press MOFFN or
place the handset on the base unit or
charger.
Note:
R To switch to the speaker, press MZN.
To switch back to the receiver, press MZN/
M
N.
R In
step 1, you can store the dialed phone
number to the phonebook by pressing and
holding MFN W for a few seconds.
Adjusting the receiver or speaker
volume
Press MDN or MCN repeatedly while talking.
Note:
R The receiver
*1
or speaker volume you set is
kept for each line (landline and cellular
lines).
*1 If the receiver volume is set to level 5
(max.), it will be changed to level 4 in the
next call.
Making a cellular call using the redial
li
st
The last 5 phone numbers dialed are stored in
the redial list (48 digits max. each).
1 MEN REDIAL
2 MbN: Select the desired entry.
3 MCELLN
R The unit starts dialing immediately in
the following situations.
– Only 1 cellular phone is paired.
– A specific line is set to make cellular
calls (page 23).
4 MbN: Select the desired cellular phone. a
MSELECTN
Erasing a number in the redial list
n Wh
en a cellular phone is paired:
1 MEN REDIAL
2 MbN: Select the desired entry. a
MMENUN
3 MbN: “Erase” a MSELECTN
4 MbN: “Yes” a MSELECTN a MOFFN
n When a cellular phone is not paired:
1 MEN REDIAL
2 MbN: Select the desired entry. a
MERASEN
3 MbN: “Yes” a MSELECTN a MOFFN
Making landline calls
1 Li
ft the handset and then dial the phone
number.
R To correct a digit, press MCLEARN.
2 Press M
N to make the call.
R T
o make the call using the
speakerphone, press MZN.
3 When you finish talking, press MOFFN or
place the handset on the base unit or
charger.
Note:
R To switch to the speaker, press MZN.
For assistance, please visit http://shop.panasonic.com/support
25
Making/Answering Calls Using the Handset
To Next Page
Loading...
