Error messages
Display message Cause/solution
Ask phone
c
o
mpany for
VM access #
R You have not stored the voicemail access number.
S
tore the number (page 80).
Main unit
no
power
or
No link. Re-
connect base
AC adaptor.
or
No link.
R Confirm the base unit’s AC adaptor is connected to
the unit and the power outlet correctly.
R The handset has lost communication with the base
unit. Move closer to the base unit and try again.
R Unplug the base unit’s AC adaptor to reset the unit.
Reconnect the adaptor and try again.
R The handset’s registration may have been canceled.
Re-register the handset (page 63).
R When “No link.” is displayed during a power
failure, place a handset on the base unit to supply
power to the base unit.
Busy
R No cellular phone is paired to the base unit. Pair a
c
ellular phone (page 20).
R The called unit is in use.
R Other units are in use and the system is busy. Try
again later.
R The handset you are using is too far from the base
unit. Move closer and try again.
R The automated call block function is in operation. Try
again later.
R Only 1 Bluetooth device can be used with the unit at
a time. Try again later.
R The voice recognition feature could not be activated.
Try again later.
Check tel line
R The supplied telephone line cord has not been
c
onnected yet or not connected properly. Check the
connections (page 12).
R If you do not connect the telephone line cord and use
only cellular lines, set the cellular line only mode
(page 22).
Checking
R The automated call block function is in operation. Try
a
gain later.
Error!!
R Recording was too short. Try again.
R S
omeone is using a cellular line or headset. Try
again later.
R The phonebook copy is incomplete (page 67). The
cellular phone is disconnected from the base unit.
Make sure that other Bluetooth devices are not
connected to the cellular phone, and try again.
For assistance, please visit http://shop.panasonic.com/support
83
Useful Information
To Next Page
Loading...
