– When the call is being received, the Caller
ID
number is displayed in the same format
as the edited number.
– After the call has ended, the caller’s phone
number is displayed in the same format as
the edited number, when reviewed from the
caller list.
For example, you can use this feature to set
the unit to ignore the area code of callers in
your area, so that you can call these local
numbers using caller information without
dialing the area code.
To activate this feature, you must edit an entry
in the caller list, then call that number. After
that, phone numbers from that caller’s area
code are edited automatically.
This feature can be set for each unit (page 55,
58). The default setting is “On”.
Note:
R Phone numbers from the 4 most recently
edited area codes are automatically edited.
Erasing selected caller
i
n
formation
Handset / Base unit
1 Pr
oceed with the operation for your unit.
Handset: MCN CID
Base unit: MCIDN
2 MbN: Select the desired entry.
3 MERASEN a MbN: “Yes” a MSELECTN
4 Proceed with the operation for your unit.
Handset: MOFFN
Base unit: MEXITN
Erasing all caller information
Handset / Base unit
1 P
r
oceed with the operation for your unit.
Handset: MCN CID
Base unit: MCIDN
2 MERASEN a MbN: “Yes” a MSELECTN
3 Proceed with the operation for your unit.
Handset: MOFFN
Base unit: MEXITN
66
For assistance, please visit http://shop.panasonic.com/support
Caller ID Service
To Next Page
Loading...
