4 Wait for the paged party to answer.
R If the paged party does not answer,
press MBACKN to return to the outside
call.
5 To complete the transfer:
Press MOFFN.
To establish a conference call:
MMENUN a MbN: “Conference” a
MSELECTN
R To leave the conference, press MOFFN.
The other 2 parties can continue the
conversation.
R To put the outside call on hold:
MMENUN a MbN: “Hold” a
MSELECTN
To resume the conference: MMENUN
a MbN: “Conference” a MSELECTN
R To cancel the conference: MMENUN a
MbN: “Stop conference” a
MSELECTN
You can continue the conversation
with the outside caller.
Intercom
Intercom calls can be made between
handsets.
Note:
R When paging unit(s), the paged unit(s)
beeps for 1 minute.
R If you receive an outside call while talking
on the intercom, the interrupt tone sounds.
To finish intercom, press MOFFN. To answer
the call, press M
/ZN.
R To change the ringer volume and ringer
tone for intercom, see page 25.
Making an intercom call
1 MMENUN a MbN: “Intercom” a
MSELECTN
2 MbN: Select the desired unit or “Voice
paging”. a MSELECTN
R If you select “Voice paging”, speak
into the microphone after the beep.
Your voice will be heard using the
speakers of all handsets, until a paged
party answers your page or until you
press MOFFN.
After the other party answers, the
speakerphone mode is turned on.
3 When you finish talking, press MOFFN.
Note:
R You can also use the MINTERCOMN soft
key, if displayed, to make intercom calls.
R You cannot use voice paging if other units
are in use.
R Voice paging is not available when a range
extender (KX-TGA405) is registered to the
base unit.
Answering an intercom call
1 When the unit is paged, lift the handset.
n To answer using the receiver
Press M
/ZN.
n To answer using the speakerphone
Press and hold M /ZN for a few
seconds.
2 When you finish talking, press MOFFN.
Turning auto intercom on/off
This feature allows the handset to answer
intercom calls automatically when it is called.
You do not need to press M
/ZN. When this
feature is set to “On”, the monitoring handset
for the baby monitor feature (page 31) will
also answer baby monitor calls automatically.
The default setting is “Off”.
1 MMENUN#273
2 MbN: Select the desired setting. a
MSAVEN a MOFFN
Note:
R This feature is not available for all handsets
paging and voice paging even if it is turned
on.
For assistance, please visit http://shop.panasonic.com/support
17
Making/Answering Calls
To Next Page
Loading...
