Panasonic KX-TS3282B - Assigning the Extension Number

17
Preparation
For assistance, please call: 1-800-211-PANA(7262)
Assigning the Extension Number
Assign the extension number to the unit to use the intercom feature.
Make sure that the unit has been connected to other units (KX-TS3282B,
KX-TS3282W and/or KX-T3281W) in parallel (p. 11-13) before programming.
Make sure that the handset is on the cradle, the AC adaptor is
connected and the SP-PHONE/HEADSET indicator light is off.
1
Press [FUNCTION/EDIT].
2
Scroll to “Assign EXT#” by pressing []
or [].
3
Press [].
• The numbers (1 to 8) that have already
been assigned to other units are not
displayed.
4
Press [] or [] to move the cursor to
select the extension number (1 to 8).
5
Press [ENTER] (Save key).
• A beep sounds.
• The extension number ([1] to [8]) is shown on the
right.
• You can exit the programming mode any time by pressing [EXIT].
• To change the extension number, start from step 1. The previous memory will be
erased.
• To exchange the extension numbers between two units, erase each number (see
below), then re-assign the number to each unit.
To erase the extension number
Repeat steps 1 to 3, and select “Erase” by pressing []. Press [ENTER]
(Save key).
•“Extension# Not assign” is displayed.
• All extension indicators flash until you assign a number to the unit.
After you connect the AC adaptor (p. 10), all of the extension indicators flash
until you assign the extension number of your unit. Even if you do not use the
intercom, assign the number. Otherwise all of the extension indicators will
continue flashing.
–––––––––––––––
Save M1,M2,M3
Save directory
▼
Set clock
Assign EXT#
–––––––––––––––
▼
Extension#
12345678 Erase
ENTER=Save
▼
▼
▼▼
▼
Extension#
1
Ex. Extension number 1
▼