Panasonic KX-TS3282B - Dialing a Stored Number

45
Advanced Operation
For assistance, please call: 1-800-211-PANA(7262)
• When using the Dial Lock (p. 57) or Call Restriction feature (p. 58), you cannot
store an item in a one-touch auto dial button ([M1] to [M3]). 3 beeps will be heard
in step 2.
• You can exit the programming mode any time by pressing [EXIT].
• If a pause is required for dialing, press [PAUSE] where needed. If required, you
can also insert [FLASH] in a phone number. Pressing [PAUSE] or [FLASH]
counts as one digit (p. 52, 53).
To erase a stored number
1
Press the one-touch auto dial button
([M1], [M2] or [M3]) you want to erase.
• The stored item is displayed with the
button number (#1 to #3).
2
Press [CLEAR].
• To stop erasing, press [] (No key).
3
Press [ENTER] (Yes key) or [CLEAR].
• A beep sounds, “Clear” is displayed and
the information is erased.
• “Empty” is displayed.
Dialing a Stored Number
1
Lift the handset or press [SP-PHONE/HEADSET] or a line button.
2
Press the desired one-touch auto dial button ([M1], [M2] or [M3]).
• The stored number is displayed and dialed.
OR
1
Press the desired one-touch auto dial button ([M1], [M2] or [M3]).
• The stored number is displayed.
2
Lift the handset or press [SP-PHONE/HEADSET] or a line button.
• You can dial numbers stored in the one-touch auto dial buttons ([M1], [M2] and
[M3]) even if the Dial Lock (p. 57) or Call Restriction feature (p. 58) is on.
John White
234-567-8901
#1
Clear?
=No ENTER=Yes
▼
▼