Panasonic KX-TS3282B - Page 24

Programmable Settings
24
Make sure that the handset is on the cradle, the AC adaptor is connected
and the SP-PHONE/HEADSET indicator light is off.
1
Press [FUNCTION/EDIT].
2
Scroll to “Ringer setting” by
pressing [] or [].
3
Press [].
4
Scroll to “Ringer pattern” by
pressing [] or [].
5
Press [].
• The current settings are displayed.
6
Select the desired ringer tone (1 to 8) by
pressing [] or [] for each line.
For Intercom you can select the ringer
tone (1 to 8), “Voice”, “Auto Ans.”
(Auto Answer) or “RoomMntr” (Room
Monitor).
To move to another line, press [] or [].
• Each time you press [] or [], the ringer
tone will change and ring. If the ringer
volume has been set to OFF for the line,
the unit will not ring (p. 22).
7
Press [ENTER] (Save key).
• A beep sounds.
• To exit the programming mode, press
[EXIT].
• You can exit the programming mode any time by pressing [EXIT].
–––––––––––––––
Save M1,M2,M3
Save directory
▼
LCD contrast
Ringer setting
Change password
▼
–––––––––––––––
Ringer volume
Ringer pattern
▼
▼
Ringer volume
Ringer pattern
Incoming call
▼
Ringer pattern
L1 L2 Intercom
1 2 3
▼
Ringer pattern
L1 L2 Intercom
1 2 Auto Ans.
▼
▼