To select the devices, click on “click to edit” and bring up the device notification schedule.
You will find the following selection/options under each device
Notification type: Select the message type for notification (all messages or urgent messages only)
Dial number: CO line access code must be entered preceding the device number (91xxx…)
Type of device: either telephone or beeper can be selected.
No. of retries: The number of times the voicemail will try to send notification if the device is busy or no answer.
Busy delay time: The length of time the voicemail will waiting before sending notification again if busy.
No answer delay: The length of time the voicemail will wait before sending notification again if no answer.
Use mode: not used, continuously or within scheduled time only*
*Note regarding use mode:
Not use: The selected device is not used for message notification
Continuously: The device is called whenever a message is recorded in the mailbox.
Scheduled: The device is called only during the selected time.
To select the time frame, Click on a day tab (Sunday – Saturday). Click “time frame 1” or “time frame 2”
You may enter the start and end time in the “start at:” and “end at:” field or drag the edges of the time
frame to mark the start and end times.
PG. 3
Please continue to next page
To Next Page
Loading...
