Programming
22
Helpline Tel. No.: U.K. 0844 844 3898 R.O.I. 01289 8333
Special programming
Increasing the range of the
base unit
You can increase the signal range of the
base unit by using a DECT repeater.
Please use only the Panasonic DECT
repeater noted on page 4. Contact your
Panasonic dealer for details.
Important:
L Before registering the repeater to this
base unit, you must turn the repeater
mode on.
L Do not use more than one repeater at
a time.
Setting the repeater mode
1 {j/OK}
2 {V}/{^}: “Base Unit Setup” i
{j/OK}
3 {V}/{^}: “Repeater Mode” i
{j/OK}
4 {V}/{^}: Select the desired setting.
i {j/OK} i {ic}
Note:
L After turning the repeater mode on or
off, w flashes on the handset
momentarily. This is normal and the
handset can be used once w stops
flashing.
TG251x_2xE(e).book Page 22 Monday, January 25, 2010 3:09 PM
To Next Page
Loading...
