Useful Information
37
Helpline Tel. No.: U.K. 0844 844 3898 R.O.I. 01289 8333
Battery recharge
Making/answering calls, intercom
I cannot remember the PIN. L Change the PIN using the following method.
1 {j/OK}
2 {V}/{^}: “Base Unit Setup” i
{j/OK}
3 {V}/{^}: “Base Unit PIN” i
{j/OK}
4 {*}{7}{0}{0}{0}
5 Enter the new 4-digit base unit PIN. i
{j/OK} i {ic}
Problem Cause/solution
The handset beeps and/or
7 flashes.
L Battery charge is low. Fully charge the
batteries (page 11).
I fully charged the batteries, but
– 7 still flashes or
– the operating time seems to
be shorter.
L Clean the battery ends (S, T) and the
charge contacts with a dry cloth and charge
again.
L It is time to replace the batteries (page 11).
The handset display is blank. L The handset is not turned on. Turn the power
on (page 14).
Problem Cause/solution
w is flashing. L The handset is too far from the base unit.
Move closer.
L The base unit’s AC adaptor is not properly
connected. Reconnect AC adaptor to the
base unit.
L The handset is not registered to the base unit.
Register it (page 40).
L Activating one touch eco mode reduces the
range of the base unit in standby mode. If
required, turn eco mode off (page 15).
Problem Cause/solution
TG251x_2xE(e).book Page 37 Monday, January 25, 2010 3:09 PM
To Next Page
Loading...
