108
Focus, Brightness (Exposure) and Color tone Settings
Taking pictures with Exposure Compensation
Recording mode:
Corrects the exposure when there is a backlight or when the subject is too dark or too
bright.
1
Press [ ] button
2
Rotate the rear or front dial to
compensate the exposure
Exposure Compensation
• You can change the setting content on the exposure
compensation screen from [Exposure Comp. Disp.
Setting] in the [Custom] ([Operation]) menu. (→199)
Under-exposed
Optimum
exposure
Over-exposed
Adjust the
exposure to the [+]
direction
Adjust the
exposure to the [-]
direction
3
Press [ ] button to set
• You can also press the shutter button halfway to set.
●
In Manual Exposure Mode, you can correct the exposure only when the ISO sensitivity is
set to [AUTO].
●
You can set the exposure compensation value in the range between –5 EV and +5 EV.
Settings can be made within a range of –3 EV to +3 EV while recording motion pictures, recording
4K photos, or recording in [Post Focus].
●
When [Auto Exposure Comp.] of [Flash] in the [Rec] menu is set to [ON], the flash output is also
automatically adjusted based on the exposure compensation value.
●
Depending on the brightness, this may not be possible in some cases.
●
When the Exposure Compensation value is out of the –3 EV to +3 EV range, the brightness of
the recording screen will no longer change. You can apply the exposure compensation value by
pressing the shutter button halfway or pressing the [AF/AE LOCK] button to lock exposure.
●
The set Exposure Compensation value is stored even if the camera is turned off. (When [Exposure
Comp. Reset] is set to [OFF])
To Next Page
Loading...
