81
DVQX1391 (ENG)
Others
No flash emitted.
• The flash becomes unavailable in the following cases.
– The flash is closed.
– Flash set to [
] (Forced Flash Off).
• Set [Shutter Type] to [AUTO] or [MSHTR]. (→55)
• Set [Silent Mode] to [OFF]. (→55)
The monitor/viewfinder is turned off although the camera is turned on.
• When a hand or an object is close to the eye sensor, the monitor display mode could be
switched to viewfinder display mode. (→22)
Cannot view pictures. There are no recorded pictures.
• A card is not inserted in the camera.
• Has the file name of the picture been changed on a computer? If so, it cannot be played back
on the camera.
→ It is recommended to use the “PHOTOfunSTUDIO” software (→74) to write pictures from
PC to card.
• Set [Playback Mode] to [Normal Play]. (→57)
A Wi-Fi connection cannot be established. Radio waves get disconnected.
Wireless access point is not displayed.
General tips for using a Wi-Fi connection
• Use within the communication range of the wireless LAN network.
• If any device, such as microwave oven, cordless phone, etc., that uses 2.4 GHz frequency
are used nearby this unit simultaneously, radio waves may get interrupted.
→ Use them sufficiently away from the device.
• When the battery indicator is flashing red, the connection with other equipment may not
start or the connection may be disrupted. (A message such as [Communication error] is
displayed.)
• When this unit is placed on a metal table or shelf, the connection may not be established
easily because the camera is affected by radio waves. Use the camera away from metal
surfaces.
About a wireless access point
• Check if the wireless access point to connect is in operating state.
• Check the radio wave condition of the wireless access point.
→ Perform the connection closer to the wireless access point.
→ Move the location or change the angle of the wireless access point.
• It may not display even if the radio waves exist depending on the setting of the wireless
access point.
→ Turn off the wireless access point and then turn it back on.
• Is the network SSID of the wireless access point set not to broadcast?
→ It may not be detected when it is set not to broadcast. Enter and set the network SSID.
Alternatively, set the network SSID of the wireless access point to broadcast.