Others
- 120 -
• Is the [REC]/[PLAYBACK] selector switch at the [!] setting? (P27)
• Is there any memory remaining on the built-in memory or the card?
> Delete the pictures which are not necessary to increase the available memory. (P40)
• The picture can become whitish if there is dirt e.g. fingerprints on the lens.
> If the lens is dirty, turn on the camera, eject the lens barrel (P8) and gently wipe the lens
surface with a soft dry cloth.
• Was this picture taken with the flash at the close range when the zoom was near [W] (1k)?
> Zoom in a little, and then take the pictures. (P35)
> Check that the exposure is correctly compensated. (P50)
> Set other than [HI-SPEED BURST] (P58), [FLASH BURST] (P59) in Scene Mode or
[BURST] (P76) of the [REC] Mode menu to [OFF].
• The focus range varies depending on the Recording Mode.
> Set to the proper mode for the distance to the subject.
• The subject is beyond the focus range of the camera. (P32)
• There is camera shake (jitter) or the subject is moving slightly. (P34)
> The shutter speed becomes slower when pictures are taken in dark places so hold the
camera firmly with both hands to take the pictures. (P28)
> When taking pictures at a slow shutter speed, use the self-timer. (P49)
> When you do not use the Digital Zoom, set it to [OFF] and the sensitivity to [ ]. (P71)
Recording
The picture cannot be recorded.
The recorded picture is whitish.
The area around where the pictures were taken becomes dark.
The recorded picture is too bright or dark.
2 or 3 pictures are taken at one time.
The subject is not focused properly.
The recorded picture is blurred.
To Next Page
Loading...
Need help?
General
