Others
- 122 -
• LCD monitor will turn off when [SLEEP MODE] (P24) is activated.
[This does not happen when using the AC adaptor (optional).]
• This camera automatically charges for flash recording and may darken the LCD monitor for
efficient charge. The monitor may darken in the following cases;
– Just after turning the camera ON
– Just after setting to Recording Mode
– When adjusting the zoom or pointing the camera toward a dark side
The LCD monitor lights up again to return to recording-ready condition after charging the flash.
• This phenomenon appears when you press the shutter button halfway to set the aperture value
and does not affect the recorded pictures.
• This phenomenon also appears when the brightness changes when the camera is zoomed or
when the camera is moved. This is because of operation of the automatic aperture of the
camera, and it is not a malfunction.
• The LCD monitor may flicker for a few seconds after turning the camera on indoors under
fluorescent light. This is not a malfunction.
• [POWER LCD] or [HIGH ANGLE] is activated. (P24)
• This is not a malfunction.
These pixels do not affect the recorded pictures.
• In dark places, noise may appear to maintain the brightness of the LCD monitor. This does not
affect the pictures you are recording.
• If the LCD monitor is pressed with a finger and pressure is applied, distortion (uneven colors)
will appear on the screen, but this is not a malfunction.
LCD monitor
The LCD monitor turns off although the camera is turned on.
The LCD monitor darkens during use.
The LCD monitor becomes darker or brighter for a moment.
The LCD monitor flickers indoors.
The LCD monitor is too bright or dark.
Black, red, blue and green dots appear on the LCD monitor.
Noise appears on the LCD monitor.
Distortion appears in the LCD monitor.
To Next Page
Loading...
Need help?
General
