22 VQT2P49 VQT2P49 23
Using [SETUP] menu (Continued)
For details about the setting procedure in the [SETUP] menu. (→15)
[VIDEO OUT]
∗
Change the video output
format when connected
to a TV, etc. (Playback
Mode only).
[NTSC]/[PAL]
• Operates when AV cable is connected.
[TV ASPECT]
Change the aspect ratio
when connected to a
TV, etc. (Playback Mode
only).
/
• Operates when AV cable is connected.
[VERSION DISP.]
Check the version of the
camera firmware.
Current version is displayed.
[FORMAT]
Use when [BUILT-IN
MEMORY ERROR]
or [MEMORY CARD
ERROR] appears, or
when formatting the built-
in memory or card.
When a card/built-in
memory is formatted,
the data cannot be
restored. Check the
content of the card/
built-in memory
carefully before
formatting.
[YES]/[NO]
• This requires a sufficiently charged battery (→9) or AC
adaptor (optional). When formatting the built-in memory,
remove any cards.
(Only inserted card will be formatted if present; built-in
memory will be formatted if no card is inserted.)
• Always format cards with this camera.
• All picture data including protected pictures will be
deleted. (→76)
• Do not turn off power or perform other operations during
formatting.
• Formatting the built-in memory may take several
minutes.
• Consult your nearest Service Center if format cannot be
successfully completed.
Item Settings, notes
For details about the setting procedure in the [SETUP] menu. (→15)
[LANGUAGE]
Change display
language.
Set the language displayed on the screen.
[DEMO MODE]
View demonstration of
functions.
[STABILIZER DEMO.]: (Only during recording)
Indicates the extent of jitter detected by the camera
(Estimate)
Extent of jitter
Extent of jitter after stabilization
Large ← Small → Large
• When the demo screen is displayed, touch [STABILIZER]
to switch the Optical Image Stabilizer between [ON] and
[OFF].
• Cannot be displayed in Playback Mode.
• To stop → Touch [EXIT]
• Recording and zoom cannot be performed during demo.
[AUTO DEMO]: View introductory Slide Show
[OFF]/[ON]
• To close → Press [MENU]
• If the camera is left switched on while connected to the
AC adaptor (optional) and with no card inserted, the
demo will automatically begin whenever no operations
are performed for approx. 2 minutes.
• [AUTO DEMO] cannot be displayed on external devices
such as TVs.
Item Settings, notes
∗
PAL video out is not available on the version DMC-FP3P sold in the U.S. and the version
DMC-FP3PC sold in Canada.
To Next Page
Loading...
