34 VQT2P49 VQT2P49 35
Changing recording information display
Taking pictures with self-timer
Recording Mode:
You can switch between various information shown on the LCD monitor, such as guide
lines and recording information.
■
Guide lines
• Reference for composition (e.g. balance) when
recording.
●
During menu display, Multi playback or Calendar playback: Display cannot be changed.
●
Guide lines are not displayed in [PHOTO FRAME] Scene Mode.
Press to change display
●
In Recording Mode
Recording information No display Guide lines
●
In Playback Mode
Picture information
Picture information +
Recording information No display
●
When set to [BURST], three pictures are taken. When set to the [FLASH BURST]
Scene Mode, five pictures are taken.
●
Focus will be automatically adjusted immediately before recording if shutter button is
pressed fully here.
●
After self-timer lamp stops flashing, it may then be lit for AF assist lamp.
●
This function cannot be used in [HI-SPEED BURST] Scene Mode.
●
In [SELF PORTRAIT] Scene Mode, [10SEC.] is not available.
We recommend using a tripod. This is also effective for correcting jitter when pressing the
shutter button, by setting the self-timer to 2 seconds.
Touch on the Quick menu (→17)
• You can also set by touching [SELFTIMER]
in the [REC] menu
Touch the time to be set
• If you are not going to use the self-timer,
touch [OFF].
• Touch [EXIT] to return to the original screen.
Self-timer indicator
(Flashes for set duration)
Take a picture
Press the shutter button fully to start recording
after the preset time.
• To cancel while in operation
→Touch [CANCEL]
To Next Page
Loading...
