73
VQT1M59
Advanced (Playback)
You can add text (comments) to pictures. After text has been registered, it can be included
in prints using [TEXT STAMP] (P74). (Only alphabetic characters and symbols can be
entered.)
Select [TITLE EDIT] on the [PLAYBACK] mode menu. (P19)
Move 3/4 to select [SINGLE] or [MULTI] and then
press [MENU/SET].
Move 3/4/2/1 to select text and then press
[MENU/SET] to register.
• Press [DISPLAY] to switch text between [A] (capitals), [a] (small
case) and [&/1] (special characters and numbers).
• The cursor at the entry position can be moved to the left with
[L], and to the right with [Z].
• To enter a blank, move the cursor to [SPACE] or to delete an entered character, move
the cursor to [DELETE], and press [MENU/SET].
• To stop editing at any time during text entry, press [‚].
• A maximum of 30 characters can be entered.
Move 3/4/2/1 to move the cursor to [EXIT] and then press [MENU/
SET] to end text input.
Press [‚] to return to the menu screen.
¢
¢ The menu screen is automatically restored when [MULTI] is selected.
• Press [MENU/SET] to close the menu.
[TITLE EDIT]
Select the picture, and then
press [MENU/SET] to set.
• [’] A is displayed for pictures that
have already been recorded with text
in [BABY1]/[BABY2] (P50) or [PET]
(P51) name settings in scene mode or
[TITLE EDIT].
[MULTI] setting
Press [DISPLAY] to set (repeat),
and then press [MENU/SET] to set.
•
The setting is canceled when
[DISPLAY] is pressed again.
• Titles cannot be changed or deleted in
[MULTI].
[SINGLE] [MULTI]
Move 2/1 to select
the picture.
Move 3/4/2/1 to
select the pictures.
1
2
3
A
4
5
6
VQT1M59_ENG.book 73 ページ ２００８年１月８日 火曜日 午後５時２１分
To Next Page
Loading...
