19
VQT1W65
Preparation
Note
Due to the camera’s specifications, it may not be possible to set some of the functions or
some functions may not work in some of the conditions under which the camera is used.
This section describes how to select the Normal picture mode settings, and the same
setting can be used for the [PLAYBACK] menu and [SETUP] menu as well.
Example: Setting [AF MODE] from [
Ø] to [š] in the Normal picture mode
( [PLAYBACK] mode menu (P73 to 82) ! [REC] mode menu (P59 to 67)
• This menu lets you
set the protection,
trimming or print
settings (DPOF), etc.
of recorded pictures.
• This menu lets you
set the coloring,
sensitivity, aspect
ratio, number of pixels
and other aspects of
the pictures you are
recording.
[SETUP] menu (P21 to 25)
• This menu lets you perform the clock settings, beep tone settings and
other settings which make it easier for you to operate the camera.
• The [SETUP] menu can be set from either the [REC MODE] or
[PLAYBACK MODE].
Setting menu items
Turn the camera on.
A [MENU/SET] button
B [REC]/[PLAYBACK] selector switch
C [MODE] button
Slide the [REC]/[PLAYBACK] selector
switch to [!], and then press [MODE].
• When selecting the [PLAYBACK] mode menu settings,
set the [REC]/[PLAYBACK] selector switch to [(], and
proceed to step
4.
Move 3/4 to select [NORMAL PICTURE],
and then press [MENU/SET].
Press [MENU/SET] to display the menu.
• You can switch menu screens from any menu item by
rotating the zoom lever.
DMC-FS25PPC-VQT1W65_eng.book 19 ページ ２００９年１月２２日 木曜日 午前１１時６分
To Next Page
Loading...
Need help?
General
