59
VQT1W65
Advanced (Recording pictures)
Note
• Return the setting to [HOME] when the vacation is finished by performing steps 1, 2 and 3.
• If [HOME] is already set, change only the travel destination, and use.
• If you cannot find the travel destination in the areas displayed on the screen, set by the time
difference from the home area.
•
The travel destination icon [
“
] appears when playing back pictures taken at the travel destination.
Using the [REC] Mode Menu
For details on [REC] mode menu settings, refer to P19.
Set the number of pixels. The higher the numbers of pixels, the finer the detail of the
pictures will appear even when they are printed onto large sheets.
Applicable modes:
ñ· ¿
∫ When the aspect ratio is [X].
¢ This item cannot be set in the Intelligent auto mode.
Move 3 to select [DESTINATION] and then press
[MENU/SET] to set.
C Depending on the setting, the time at the travel destination
area or the home area is displayed.
Move 2/1 to select the area the travel
destination is in and then press [MENU/SET] to
set.
D Current time of the destination area
E Time difference
• If daylight saving time [ ] is used at the travel destination,
move 3. (The time advances by one hour.) Move 3 again to
return to the original time.
Press [MENU/SET] to close the menu.
@ [PICTURE SIZE]
(12M) 4000k3000 pixels
(8M )
¢
3264k2448 pixels
(5M ) 2560k1920 pixels
(3M ) 2048k1536 pixels
(2M )
¢
1600k1200 pixels
(0.3M )
¢
640k480 pixels
DMC-FS25PPC-VQT1W65_eng.book 59 ページ ２００９年１月２２日 木曜日 午前１１時６分
To Next Page
Loading...
Need help?
General
