97
VQT1W65
Others
Troubleshooting
First, try out the following procedures (P97–103).
• The battery is not inserted correctly. (P14)
• The battery is exhausted.
• Is [AUTO LCD OFF] (P23) of the [ECONOMY] mode active?
> Press the shutter button halfway to cancel these modes.
• The battery is exhausted.
• The battery is exhausted.
• If you leave the camera on, the battery will be exhausted.
> Turn the camera off frequently by using the [ECONOMY] mode etc. (P23)
• Is the temperature of the battery excessively high or low? If it is, it will take longer than usual to
charge the battery or charging may remain incomplete.
• Are the terminals of the charger or battery dirty?
> Wipe off the dirt using a dry cloth.
• Is the [REC]/[PLAYBACK] selector switch at the [!] setting? (P26)
• Is there any memory remaining on the built-in memory or the card?
> Delete the pictures which are not necessary to increase the available memory. (P35)
[NO BATTERY POWER REMAINS]
• The remaining battery power is low.
> Charge the battery.
[THIS BATTERY CANNOT BE USED]
• The battery cannot be recognized by the camera.
> Use a genuine Panasonic battery. If this message is displayed even when a genuine
Panasonic battery is used, contact the dealer or your nearest Service Center.
• The battery cannot be recognized as its terminal is dirty.
> Remove any dirt etc. from the terminal.
If the problem is not resolved, it may be improved by selecting [RESET]
(P24)
on the
[SETUP] menu when taking pictures.
Battery and power source
The camera cannot be operated even when it is turned on.
The LCD monitor turns off while the camera is turned on.
The camera turns off immediately after it is turned on.
The [CHARGE] lamp flashes.
Recording
The picture cannot be recorded.
DMC-FS25PPC-VQT1W65_eng.book 97 ページ ２００９年１月２２日 木曜日 午前１１時６分
To Next Page
Loading...
Need help?
General
