61
VQT1W65
Advanced (Recording pictures)
Note
• The ends of the recorded pictures may be cut at printing so check before printing. (P102)
For details on [REC] mode menu settings, refer to P19.
The camera automatically sets the optimum ISO sensitivity and shutter speed to suit the
movement of the subject and brightness of the scene to minimize the jitter of the subject.
Applicable modes:
·
[OFF]/[ ]/[ ]/[ ]
• The upper limit of the ISO sensitivity can be set.
• The higher the value set for the ISO sensitivity, the more the jitter is reduced but the greater the
amount of picture noise.
Note
• Depending on the brightness and how fast the subject is moving, jitter may not be avoided.
• Movements may not be detected when a moving subject is small, when a moving subject is at
the edge of the screen or when a subject has moved at the very moment when the shutter
button was pressed fully.
• To avoid picture noise, we recommend decreasing maximum ISO sensitivity level or setting
[COLOR MODE] to [NATURAL]. (P66)
For details on [REC] mode menu settings, refer to P19.
This allows the sensitivity to light (ISO sensitivity) to be set. Setting to a higher figure
enables pictures to be taken even in dark places without the resulting pictures coming out
dark.
Applicable modes:
·
[AUTO]/[80]/[100]/[200]/[400]/[800]/[1600]
[X]: [ASPECT RATIO] of a 4:3 TV
[Y]: [ASPECT RATIO] of a 35 mm film camera
[W]: [ASPECT RATIO] of a high-definition TV, etc.
[X][Y][W]
[INTELLIGENT ISO]
> [SENSITIVITY]
ISO sensitivity
80 1600
Recording location
(recommended)
When it is light (outdoors) When it is dark
Shutter speed Slow Fast
Noise Less Increased
DMC-FS25PPC-VQT1W65_eng.book 61 ページ ２００９年１月２２日 木曜日 午前１１時６分
To Next Page
Loading...
Need help?
General
