- 71 -
Recording
Applicable modes:
Pictures are taken continuously while the shutter button is pressed.
[Burst]
Settings Description of settings
[˜]
([Burst On])
Burst speed approx. 1.3 pictures/second
• You can take pictures until the capacity of the built-in memory or the card
is full.
• The burst speed becomes slower halfway. The exact timing of this
depends on the type of card and the Picture Size.
• The focus is fixed when the first picture is taken.
• The exposure and White Balance are adjusted each time you take a
picture.
• The Burst speed (pictures/second) may become slower depending on
the recording environment, such as in dark places, if the ISO sensitivity is
high etc.
[]
([Hi-Speed Burst])
Burst speed approx. 10 pictures/second
Number of recordable
pictures
max. 100 pictures
• This can be set only during Normal Picture Mode.
• The picture size is fixed to 3M (4:3), 2.5M (3:2), 2M (16:9) or 2.5M (1:1).
• The Burst speed changes according to the recording conditions.
• The number of Burst recording pictures are limited by the picture-taking
conditions and the type and/or status of the card used.
• The number of Burst recording pictures may increase when you use a
card with fast writing speed or card is formatted.
• The focus, zoom, exposure, White Balance, shutter speed and ISO
sensitivity are fixed to the settings for the first picture.
• The ISO sensitivity is automatically adjusted. However, the ISO
sensitivity is increased to make the shutter speed become high-speed.
• Depending on the operating conditions, it may take time to take the next
picture if you repeat taking a picture.
[]
([Flash Burst])
Number of recordable
pictures
max. 5 pictures
• Still pictures are taken continuously with flash.
• This can be set only during Normal Picture Mode.
• The picture size is fixed to 3M (4:3), 2.5M (3:2), 2M (16:9) or 2.5M (1:1).
• Settings for focus, zoom, exposure, shutter speed, ISO sensitivity, flash
output are fixed to the first picture.
• Number of recordable pictures will be fixed to 5 pictures when the
self-timer is used.
• The flash setting is fixed to [‰].
[OFF] —
To Next Page
Loading...
