Advanced (Recording pictures)
- 120 -
For details on [REC] mode menu settings, refer to P29.
This allows the sensitivity to light (ISO sensitivity) to be set. Setting to a higher figure
enables pictures to be taken even in dark places without the resulting pictures coming out
dark.
Applicable modes:
³±´²
[AUTO]/[100]/[200]/[400]/[800]/[1600]
Note
•
When setting to [AUTO], the ISO sensitivity is automatically adjusted to a maximum of value set
with [ISO LIMIT SET].
• ISO sensitivity will adjust automatically depending on brightness within the maximum setting of
[ISO400] ([ISO800] when the flash is used) when [AUTO] is selected for [ISO LIMIT SET].
• The setting is not available when [INTELLIGENT ISO] is being used. ([ ] is displayed.)
• If picture noise becomes a problem, we recommend that you take pictures after lowering the
maximum ISO sensitivity level, increasing the setting for [NOISE REDUCTION] under
[PICT.ADJ.], or lowering the setting for each of the items other than [NOISE REDUCTION].
(P132)
For details on [REC] mode menu settings, refer to P29.
It will select optimal ISO sensitivity with set value as limit depending on the brightness of
the subject.
Applicable modes:
³±´²
[AUTO]/[200]/[400]/[800]/[1600]
Note
• The upper limit of the ISO sensitivity can be set.
• The higher the value set for the ISO sensitivity, the more the jitter is reduced but the greater the
amount of picture noise.
• It will work when the [SENSITIVITY] is set to [AUTO] or [INTELLIGENT ISO] is set to [ON].
[SENSITIVITY]
ISO sensitivity
100 1600
Recording location
(recommended)
When it is light (outdoors) When it is dark
Shutter speed Slow Fast
Noise Less Increased
[ISO LIMIT SET]
To Next Page
Loading...
