115
5. 4K Photo and Drive Settings
Taking Pictures using Burst Mode
Applicable modes:
Pictures are taken continuously while the shutter button is pressed.
•
Pictures taken with a burst speed of [SH] will be recorded as a single burst group (P182).
1
Set the drive mode dial to [ ].
2
Focus on the subject and take a picture.
• Hold down the shutter button fully to activate the Burst Mode.
∫ Setting the burst rate
Select the menu. (P51)
¢1 Number of recordable pictures
¢2 When recording is performed under the test conditions specified by Panasonic.
The burst speed will become slower halfway. However, pictures can be taken until the
capacity of the card becomes full. Depending on recording conditions, the number of burst
pictures that can be taken will be reduced.
• The picture size will be fixed to [S] when [Burst Rate] is set to [SH].
• The burst speed may become slower depending on the following settings.
– [Picture Size] (P190)/[Quality] (P191)/[Sensitivity] (P108)/Focus Mode (P91)/[Focus/Release
Priority] (P211)
> [Rec] > [Burst Rate]
[SH]
(Super high
speed)
[H]
(High speed)
[M]
(Middle
speed)
[L]
(Low speed)
Burst speed
(pictures/
second)
Mechanical
shutter,
Electronic Front
Curtain
—
9 (AFS)
6 (AFC)
62
Electronic Shutter 40
10 (AFS)
6 (AFC)
62
Live View during Burst Mode None None Available Available
¢1
With RAW files — 45 or more
¢
2
Without RAW files Max. 120 300 or more
¢
2
AFS
L
4:3
H
To Next Page
Loading...
