10. Using the Wi-Fi function
250
Wi-Fi function
∫ Before Use
•
Set the date and time settings in advance. (P34)
• To use the Wi-Fi function on this unit, a wireless access point or a destination device equipped
with the wireless LAN function is required.
∫ About the Wi-Fi connection lamp
∫ About the [Wi-Fi] button
In these operating instructions, a function button to which [Wi-Fi] is assigned is referred to
as the [Wi-Fi] button.
(By default, [Wi-Fi] is assigned to [Fn6] when the camera is in Recording Mode, while it is
assigned to [Fn1] when the camera is in Playback Mode.)
•
For information about the function button, refer to P55.
Steps for pressing [Wi-Fi] (in Recording Mode)
1 Touch [ ].
2 Touch [ ].
When the camera is not connected to Wi-Fi, press [Wi-Fi]. The camera will then be
ready to be connected to the smartphone. You can connect the camera directly to
the smartphone. (P253)
•
When the camera is ready to be connected, you can press [DISP.] to connect with the same
settings as used previously. This is a convenient and quick way to establish a connection.
(P284)
Lit blue: When the Wi-Fi function is ON or connected by
Wi-Fi
Blinking blue: When sending picture data
Fn7
Fn6
Fn8
Fn9
SNAP
Fn10
Fn6
To Next Page
Loading...
