99
4. Focus, Brightness (Exposure) and Colour tone Settings
You can set the focus position by selecting the group of AF areas.
The 49 AF areas are divided into groups, each consisting of 9
areas (on the edge of the screen, 6 or 4 areas).
1 Press 2 ().
2 Select [ ] and press 4.
3 Press 3/4/2/1 to select an AF area group.
4 Press [MENU/SET] to set.
•
Only [i] display (centre point of selected group) will remain on
the screen.
• Setting of the AF area frame is cleared when [MENU/SET] is
pressed or [ ] is touched.
You can set the focus position precisely by enlarging the screen.
•
The focus position cannot be set at the edge of the screen.
1 Press 2 ().
2 Select [ ] and press 4.
3 Press 3/4/2/1 to set the focus position and then
press [MENU/SET].
4 Move [+] to the position to be in focus.
•
When the picture is displayed in windowed mode, you can enlarge/reduce the picture by
approximately 3
k to 6k; when the picture is displayed in full screen, you can enlarge/
reduce the picture by approximately 3
k to 10k.
• You can also take pictures by touching [ ].
5 Press [MENU/SET] to set.
When selecting [ ]
When selecting [ ]
Button
operation
Touch
operation
Description of operation
3/4/2/1 Touching Moves [+].
Pinching out/in Enlarges/reduces the screen in small steps.
s Enlarges/reduces the screen in large steps.
s
Switches the enlarged display (windowed/full screen)
[DISP.] [Reset] Resets [+] back to the centre.
To Next Page
Loading...
