143
VQT3A36
Playback/Editing
You can add text (comments) to pictures. After text has been registered, it can be stamped
in prints using [TEXT STAMP] (P144). (Only alphabetic characters and symbols can be
entered.)
1 Select [TITLE EDIT] on the [PLAYBACK] Mode menu. (P55)
2 Press 3/4 to select the item and then press [MENU/SET].
•
When [SINGLE IN BURST GROUP] or
[MULTI IN BURST GROUP] is selected, press 3/4/2/1 to
select Burst Picture Group, and press [MENU/SET] to proceed to
step
3.
4 Enter the text. (P116)
•
Press [‚] to return to the menu screen. (The menu screen is automatically restored when
[MULTI] is selected.)
Note
•
To delete the title, erase all the text in the text input screen.
• Text can be scrolled if all of the registered text does not fit on the screen.
• You can print out texts (comments) using the “PHOTOfunSTUDIO 6.0 BD Edition” bundled
software on the CD-ROM (supplied).
• You can set up to 100 pictures at one time with [MULTI].
• Title editing is disabled during the following conditions:
– Motion pictures
– Pictures taken with [ ], [ ] or [ ]
– Pictures recorded with other equipment
[TITLE EDIT]
3
Select the picture, and then press
[MENU/SET] to set.
•
[’] is displayed for pictures with titles
already registered.
[MULTI] setting
Press [DISPLAY] to set (repeat), and
then press [MENU/SET] to set.
• The setting is canceled when [DISPLAY]
is pressed again.
[SINGLE] [MULTI]
Press 2/1 to select
the picture.
Press 3/4/2/1 to
select the pictures.
DMC-GH2H&GH2K&GH2PP-VQT3A36_eng.book 143 ページ ２０１０年１０月１９日 火曜日 午前１１時３分
To Next Page
Loading...
Need help?
General
Weight and Dimensions
