VQT3A36
68
Recording
[REC] Mode:
Taking Pictures using the Built-in Flash
A To open the flash
Slide the flash open lever.
B To close the flash
Press the flash until it clicks.
•
Be sure to close the flash when not in use.
• The flash setting is fixed to [Œ] while the flash is
closed.
Note
•
Be careful not to catch a finger when closing a flash bulb.
Applicable modes:
Set the built-in flash to match the recording.
•
Open the flash.
1 Select [FLASH] in the [REC] Mode menu. (P55)
2 Press 3/4 to select a mode and press [MENU/SET].
•
For information about flash settings that can be selected, refer to “Available flash settings
by Recording Mode
”. (P70)
Switching to the appropriate flash setting
DMC-GH2H&GH2K&GH2PP-VQT3A36_eng.book 68 ページ ２０１０年１０月１９日 火曜日 午前１１時３分
To Next Page
Loading...
