VQT3A36
186
Others
> Check that the exposure is correctly compensated. (P75)
• Is the AE Lock (P86) applied incorrectly?
> Unset the settings of White Balance Bracket (P89).
> Set [ASPECT BRACKET] (P124) to [OFF].
• The subject is beyond the focus range of the camera. (P34)
• There is camera shake (jitter) or the subject is moving slightly. (P74)
• Is [FOCUS PRIORITY] in the [CUSTOM] menu set to [OFF]? (P130)
In this case, the picture may not be properly focused even if [AFS] or [AFC] in Focus Mode is set.
• Is [SHUTTER AF] in the [CUSTOM] menu set to [OFF]? (P131)
• Is the AF Lock (P86) applied incorrectly?
• The shutter speed will become slower and the Optical Image Stabilizer function may not work
properly when taking pictures especially in dark places.
> We recommend holding the camera firmly with both hands when taking pictures. (P36)
> We recommend using a tripod and the self-timer (P80) when taking pictures with a slow
shutter speed.
• Is there any memory remaining on the card?
• Is the ISO sensitivity high or the shutter speed slow?
(ISO sensitivity is set to [AUTO] when the camera is shipped. Therefore, when taking pictures
indoors etc. noise will appear.)
> Decrease the ISO sensitivity. (P90)
> Increase the setting for [NOISE REDUCTION] in [FILM MODE] or lower the setting for each
of the items other than [NOISE REDUCTION]. (P117)
> Take pictures in bright places.
> Set the [LONG SHTR NR] to [ON]. (P123)
• Is the [PICTURE SIZE] (P119) or the [QUALITY] (P120) set low?
• Is the [DIGITAL ZOOM] set? (P66)
The recorded picture is too bright or dark.
Multiple pictures are taken at one time.
The subject is not focused properly.
The recorded picture is blurred.
The Optical Image Stabilizer is not effective.
Taking pictures using White Balance Bracket/[ASPECT BRACKET] is not
possible.
The recorded picture looks rough.
Noise appears on the picture.
Under fluorescent lighting, flicker or horizontal bars may be seen.
• This is characteristic of MOS sensors which serve as the camera’s pickup
sensors.
This is not a malfunction.
• If the flicker or horizontal bars stand out, record in the Creative Motion
Picture Mode and set the shutter speed to 1/100 in areas where the supply
frequency is 50 Hz, or 1/60 in areas of 60 Hz.
DMC-GH2H&GH2K&GH2PP-VQT3A36_eng.book 186 ページ ２０１０年１０月１９日 火曜日 午前１１時３分
To Next Page
Loading...
Need help?
General
Weight and Dimensions
