389
13. Others
• Confirm that the login information (login ID/user name/email address/password) is correct.
• Web service server or the network may be busy.
> Try again after a while.
> Check the site of the web service you are sending the image to.
• Is the size of the image too large?
> Reduce the image size at [Size] (P309), and then send.
> Transmit after dividing the motion picture with [Video Divide] (P274).
• It may take longer time to transmit when distance to the wireless access point is far.
> Transmit closer to the wireless access point.
• Upload may not complete when it is disconnected while transmitting the image.
• It may take some time after uploading the image to be reflected in the web service depending
on the status of the server.
> Wait for a while and try again.
• You can check the transmission status on the web service link settings by logging into “LUMIX
CLUB”.
• The images in the web service cannot be saved (downloaded) to this unit.
> Do not delete the uploaded images, and make a backup of them.
• The images uploaded to the web service cannot be displayed or deleted by this unit.
> Perform the task using a smartphone or a PC.
• Image cannot be transmitted when the battery indicator is flashing red.
• Is the size of the image too large?
> Reduce the image size at [Size] (P309), and then send.
> Transmit after dividing the motion picture with [Video Divide] (P274).
• File format of the motion picture that can be sent differs depending on the destination. (P307)
• Capacity or number of images in the web service is full.
> Login to “LUMIX CLUB”, and check the status of the destination on the web service link
settings.
Images cannot be transmitted to the web service.
It takes time to transmit an image to the web service.
The image that was supposed to have uploaded to the web service is not there.
I would like to return the image in the web service to the camera.
I cannot display or delete the images uploaded to the web service by this unit.
Transmission of the image fails midway. Some images cannot be transmitted.
To Next Page
Loading...
Need help?
General
