Preparation
16
VQT0U87
Inserting/Removing
the Batteries
• Check that the camera is turned off and
that the lens is retracted.
• Use oxyride batteries (supplied), alkaline
batteries (optional) or Ni-MH batteries
(optional).
1 Slide the battery door to open it.
2 Insert the batteries with the + and
- poles aligned correctly.
3 1 Close the battery door.
2 Slide the battery door to the
end and then close it firmly.
• Select the battery type being used in
[BATTERY TYPE] in the [SETUP] menu.
(P21)
• Remove the batteries after use.
• When batteries have been inserted for
more than 3 hours, the clock setting is
stored in the camera for approximately
3 months even if the batteries are
removed.
• Do not remove the card or the batteries
while the camera accesses the built-in
memory or a card. The data may be
damaged. (P17)
• Remove the batteries after the LCD
monitor and the status indicator
(green) turn off. Otherwise, the settings
on the camera may not be stored
properly.
Inserting/Removing
the Card (Optional)
• Check that the camera is turned off and
that the lens is retracted.
• You can record or play back pictures
on the built-in memory when you are
not using a card. (P17)
1 Slide the card door to open it.
VQT0U87ENG.book 16 ページ ２００５年１２月２７日 火曜日 午後７時１２分
To Next Page
Loading...
Need help?
General
