Advanced
39
VQT0U87
Taking Pictures using
the Built-in Flash
A: Photo flash
Do not cover it with your fingers or other
objects.
∫ Switching to the appropriate flash
setting
Set the flash to match the recording.
Press 1 [ ] to switch the flash
setting.
• For information about flash settings that
can be selected, refer to “Available flash
settings by recording mode” (P40).
:AUTO
The flash is automatically activated when
the recording conditions make it necessary.
: AUTO/Red-eye reduction
¢1
The flash is automatically activated when
the recording conditions make it necessary.
It is activated once before the actual
recording to reduce the red-eye
phenomenon (eyes of the subject
appearing red in the picture) and then
activated again for the actual recording.
• Use this when you take pictures of
people in low lighting conditions.
: Forced ON
The flash is activated every time regardless
of the recording conditions.
• Use this when your subject is back-lit
or under fluorescent light.
: Forced ON/Red-eye reduction
¢1
• The flash setting is set to Forced ON/
Red-eye reduction only when you set
[PARTY] (P52) or [CANDLE LIGHT]
(P52) in scene mode.
: Slow sync./Red-eye reduction
¢1
If you take a picture with a dark background
landscape, this feature will slow the shutter
speed when the flash is activated so that
the dark background landscape will
become bright. Simultaneously it reduces
the red-eye phenomenon.
• Use this when you take pictures of
people in front of a dark background.
: Forced OFF
The flash is not activated in any recording
conditions.
• Use this when you take pictures in
places where the use of the flash is not
permitted.
¢1 The flash is activated twice. The
subject should not move until the
second flash is activated.
SCN1
SCN
2
VQT0U87ENG.book 39 ページ ２００５年１２月２７日 火曜日 午後７時１２分
To Next Page
Loading...
Need help?
General
