Application (Record)
Taking pictures with Auto Focus
VQT5E85
- 92 -
■
Changing the position and size of the AF area ([Focus Area Set])
When [AF Mode] is set to [ ] (1-area-focusing), you can move the position or size of
the AF area at the centre.
Select [AF Mode] from the [Rec] menu and press
[MENU/SET] (→60)
Use to select [ ] from the [AF Mode] items and
press [DISP.] button
To change the AF area
To move the position of the AF area: Press
To change the size of the AF area: Turn the control dial
• To restore the AF area to its initial state (position and
size) → Press [DISP.] button.
Press [MENU/SET]
• If the [Fn] button is set to [Focus Area Set] (→133), press
the [Fn] button and then perform steps and after.
●
Cannot be changed during motion picture recording.
●
When the AF area is small, it may be difficult to adjust the focus.
●
When [Metering Mode] is set to [ ] (spot-focusing), the new position of the AF area
will be measured.
●
The position and size cannot be changed in [Miniature Effect] of [Creative Control]
mode.
To Next Page
Loading...
