Wi-Fi / Bluetooth – Connecting to a Smartphone
657
Using Password Authentication to Connect
You can enhance Wi-Fi connection security by using password
authentication through either QR code or manual input.
Scanning QR code to connect
1 Set [Wi-Fi Password] on the camera to [ON].
• [] [] [LAN / Wi-Fi] [LAN / Wi-Fi Setup] [Wi-Fi
Password] [ON]
2 Display the QR code (C).
• [] [] [LAN / Wi-Fi] [Wi-Fi Function] [New Connection]
[Control With Smartphone]
• You can also perform the same operation by pressing the Fn button assigned
with [Wi-Fi]. (Fn Buttons: 536)
• Press or to enlarge the QR code.
3 On the smartphone, start up “LUMIX Sync ”.
• If a message is displayed indicating that the smartphone is searching for
cameras, close the message.
4 Select [ ].
5 Select [Wi-Fi connection].
6 Select [QR code].
7 Scan the QR code displayed on the screen of the camera using “ LUMIX Sync”.
• (iOS devices) When a message to confirm the change of destination is
displayed, select [Join].
To Next Page
Loading...
