EN10
When taking out, please keep the body horizontal to
prevent the rubbish in the dust bin from falling out.
Disposing of the dust (Maintenance)
Disposing of the dust (Maintenance)
When the dust sensor lamp and the battery status
indicator lamp fl ash at the same time (In this case, the
suction power is weakened), please timely clean up the
rubbish and perform maintenance.
Since rubbish may not accumulate in the dust bin
evenly, please confi rm the rubbish accumulation directly.
In order to prevent the suction power from dropping,
rubbish that easily clogs such as sand should be
removed as soon as possible even if the amount is
small, and the dust bin should be maintained.
The dust box may become full earlier on new carpets
because of the presence of loose threads.
(As the number of vacuuming increases, the carpet
fl oating wool will gradually decrease)
Note
It is advised to remove the rubbish immediately after
each vacuuming and perform detailed maintenance.
Not only will this prevent rubbish from producing
odors, but also prevent the dust in the dust bin
from adhering to subtle and easily-blocking rubbish
(e.g., dust, dust from cotton quilts, etc.), resulting in
weakened suction power.
Recommendation
Turn off the vacuum cleaner when cleaning up rubbish or
during maintenance.
1
Press the dust bin release button to remove the dust bin
Please do not use substances such as detergent,
bleach, gasoline, thinner, or alcohol
(To avoid cracks and colour change)
Please dry the dust bin completely for about 24 hours
immediately after washing
(To avoid odor or clogging)
Please do not use blow dryer or similar device to dry it
(To avoid malfunction)
Request
1
Rotate as shown in the
fi gure to make align
with
and open
and remove the fi lter
2
Remove the sponge fi lter
1
Reinstall the sponge fi lter back
Maintain the dust bin
Reinstall it
Remove the dust bin
,
clean up the rubbish
When the dust bin is full
or the suction power is
weakened, please clean up the
rubbish in time and perform
maintenance.
To Next Page
Loading...
