18
INSTALLATION
Installation
1. Remove the packing tape and clean up.
Remove all the tapes that are securing the doors and the inner attachments. Open the doors for ventilation.
If the outer panels are dirty, wet a cloth with a diluted neutral detergent and wipe them. (Undiluted
detergent can damage the plastic components. For the dilution, refer to the instruction of the detergent.)
Wipe off the residual detergent with a wet cloth and then wipe off any moisture.
Note: Remove the cable tie banding the power supply cord. Prolonged banding may cause the corrosion
of the cord coating.
WARNING
Do not leave the plastic wrapping bags within reach of children. If the bag is placed over a child’s
head, it can block the mouth and nose and cause suffocation.
2. Set the humidifying pan and humidifying pan
cover (Fig. 1).
3. Set 4 trays (Fig. 2).
4. Adjust the leveling feet.
Adjust the leveling feet by turning them
counterclockwise to level the incubator (Fig. 3)
Note: Incubating on a leaning tray may have a bad
influence on the cultivation.
4 Trays
Leveling feet
Shrink
Strech
Humidifying pan
Fig. 1
Fig. 2
Fig. 3
Humidifying pan
cover
To Next Page
Loading...
