To Next PageTo Next PageWhy is the gas density slow to recover in my Panasonic MCO-170MUV Accessories?
If the gas density recovers slowly even when the gas pressure is normal, the HEPA filter might be clogged. In this case, it is recommended to contact our sales representative or agent.
Why is gas not being injected into my Panasonic MCO-170MUV?
Gas is not injected until the temperature of the CO sensor becomes stable enough, approximately 1 hour after turning ON the power switch or recovering from a power failure. Please wait for an hour.
What to do if H O decontamination cannot be performed on my Panasonic Accessories?
If the UV lamp is burned out, H O decontamination cannot be performed. Please, check the UV lamp.
What to do if “Err34: H2O2 Volume” is activated during H O decontamination cycle in Panasonic MCO-170MUV?
If the total operating time of the H O generator exceeds 5,000 hours, it may be the end-of-life of the generator. Replace the H O generator.
Why does the UV lamp light when the outer door is open on my Panasonic MCO-170MUV Accessories?
Check if something is pushing the door switch.
How to troubleshoot a Panasonic Accessories incubator that does not operate at all?
Ensure the incubator is plugged in. Also, check for any power outages or tripped circuit breakers that may have interrupted the power supply.
What to do if the outer door does not open on my Panasonic Accessories?
Either turn ON the power switch or use the accessory unlock key to override the electric lock.
What to do if the chamber humidity does not rise in my Panasonic MCO-170MUV Accessories?
Ensure there is enough sterile distilled water in the humidifying pan. Add more if necessary.
General| Brand | Panasonic |
|---|---|
| Model | MCO-170MUV Series |
| Category | Accessories |
| Language | English |
Details the interface and display elements of the incubator's touch panel.
Specifies the required environmental conditions and location for installing the incubator.
Guides on setting chamber temperature, CO2, O2 levels, and high limit temperature alarms.
Explains the automatic switching between N2/O2 gas cylinders when one becomes empty.
Configures automatic temperature, CO2, and O2 density alarms, including delay settings.
Safety guidelines for handling the H2O2 reagent and performing decontamination procedures.
Instructions for connecting CO2 gas cylinders to the auto changer system.
Checks and countermeasures for when the incubator fails to power on or operate.
Troubleshooting steps when the incubator triggers an alarm or error message.
Troubleshooting for situations where CO2 or O2 gas is not being supplied to the chamber.
Steps to resolve issues preventing the H2O2 decontamination process from starting or completing.
