Panasonic MFDLTB4BM - User Manual

No. SX-DSV03335
REFERENCE SPECIFICATIONS
MODEL
Product Name AC Servo Driver
Product No. MINAS A6B for linear motor/DD motor
(standard type/multi-function type)
Issued on Mar. 20, 2019
Reviced on Apr. 8, 2020
Industrial Device Solution Business Unit, Industrial Device Business Division,
Industrial Solutions Company, Panasonic Corporation
7-1-1 Morofuku, Daito-City, Osaka 574-0044, Japan
Phone:+81-(0)72-871-1212
Fax :+81-(0)72-870-3151

Panasonic MFDLTB4BM Specifications

General

Model	MFDLTB4BM
Category	Servo Drives
Compatible Motor Capacity	0.4kW
Output Power	0.4 kW
Type	AC Servo Driver
Control Mode	Speed, Torque, Position
Protection Features	Overcurrent protection, Overvoltage protection, Undervoltage protection, Overheat protection

Summary

REFERENCE SPECIFICATIONS

3. Product Line-up

Details the available servo drive models categorized by type and specifications.

3-1 Standard type

3-2 Multi-function type

4. Specifications

Provides basic electrical and environmental specifications for the servo driver.

7. Configuration of connectors and terminal blocks

Details the pin assignments and functions of various connectors and terminal blocks.

7-1 Power connectors XA, XB, XC, XD and terminal block

Explains connections for power input, control power, regenerative resistor, and motor output.

7-4 Safety function connector X3

Explains the connector for functional safety inputs and outputs (supported on multi-function type).

7-5 Parallel I;O connector X4

Details input and output signal connections, including common and control inputs/outputs.

7-6 Feedback scale connector X5

Describes connections for feedback scale signals (serial, A/B/Z phase) and power.

7-9 Input;output signal interface

8. Wiring and system configuration

Covers wiring practices, cable specifications, and system configuration guidelines.

8-1 Wire rods used and maximum wiring length

8-2 Cable side connector

8-3 Precautions for wiring

Provides essential safety and installation guidelines for proper wiring.

8-4 Dynamic brake

Explains the function, operation, and precautions for the dynamic brake.

8-5 Mounting direction and interval

9-3 Peripheral device configuration

10. Safety precautions

Covers essential safety warnings and precautions for handling and operating the servo driver.

14. Specification for each model

Details specifications for individual servo driver models.